Skinny-Tube pumping, (STP) first impressions!

[Big10]

Length: FL seems to be about an inch longer, I will not measure ELBP until at least 2 more weeks pass.
Girth: Might be partial swelling still, but I have gained 3/16" in 3 weeks of PE and 1 week of STP
(skinny-tube pumping) I also jelq, most of it in a tub of hot water. Girth has went from 6" erect to 6-3/16"
which is really affecting the wife in a positive way!

I have used the STP method for like 2 hrs. a day on my training days. Long drive to work! It really feels like a good pull, better than any hanging I have done at any weight! And it pumps the head pretty well.

5" 7" ????

[titanium30]

Did you make or buy the skinny tube? How much vacuum for how long?

You sound like you are sold on pumping for a component of PE. I have just started and am incorporating pumping as well as jelk & stretching. Would like to see gains in girth. Sure come out of the pump huge! I'd think that if a guy did that for months that some of it would be retained.

titanium

Which pump do you guys like best? These pump threads are so confusing, with all the stuff people are putting together. Isn't there one "all-in-one" solution out there that works well?

[Big10]

now, this is just me, but I have done this alot and
I can take up to 10" Hg ln the vacuum guage! This seems to be plenty, and probably best results from 7-9"
vacuum. I have never gotten any blisters or other bad guys from these higher suctions, the head can withstand higher readings with no ill effects!
CAREFULLY try slightly higher vacuum if U do this!
Maybe it is because I have pumped for years, and usually at too high of a vacuum in the past.

BigBob,
What is the skinny tube compared to a reguler tube? Is it just that your penis fills up the diameter of the chamber and then all the pull is lengthwise?
Thanks,
2smooth

[phat9]

the general principle is obvious: the skinnier the tube, the more outward the pull on the head, which increases length, while the fatter the tube, the more sideways is the vacuum pull, which increases girth. It is a tradeoff, skinny for length and fat for girth.

I have a very fat tube and it gets girth but it doesn't do much for length unless I pump for long time periods or use excessive vacuum (BigBob, be careful above 7 psi!).

I am thinking of getting a skinny tube just to see what difference it makes and to mix up my routines.

[Big10]

Yes, I am very careful and it seems that the higher suction has no ill effects. I monitor this very closely.
Another thing, I can get the "ELECTRIC" feeling about 20-30 minutes into my STP routine!!! Feels like it is 100% lig pull too, no skin stretch! I also got a 9.25"+ flaccid stretched BP length, my measuring tool stops at 9"!!!
It coulda been as long as 9.5, but I am being conservative.
AT LEAST 9.25"! How does FBPL relate to Erect BPL potential?
Seems like I am on the right track!

[phat9]

Wow, an "electric" feel with pumping!? Just goes to show you how different guys respond totally differently do PE routines. I doubt I could ever get electic from pumping.

My FPBL varies so widely I could not say. I have measured over 8, but that was not after pumping. My tube is so wide it does not promote length. I have gotten over 9 in the tube but not quite so long when I take it off, of course I have gotten as thick as 10, but usually on a non-viagra assisted 1 hour pump routine, I'm 8-8.5ish thick.

Like I said, I think I am going to get the skinnyest tube I can get by with, about 2-2 1/4 wide, and see how it works on length. I'm still more a hanging guy, all the way, with jelqs to bring circulation back to the member after heavy and prolonged hanging.

I hate to tell you, but I have given up on some "rule" of thumb between stretched size and erect size. I thought there was some rule there, but now I am not so sure after over a year of PE and reading posts of others. I have even seen some on here that say their erect size is a bit greater than their "stretched" size????? If there was such a rule, believe me, I'd be well over ten inches long now. Don't get your hopes up too much on that one, but it probably means more for some than others.

[Big10]

OK, sounds right, but I had maybe hoped that
an old-timer could tell me that FBPL going up
was gonna equal a sure gain. I was glad to see
it that long tho!
What I really need is a BJ from some porno-queen
and measure it right b4 I blow off, THEN I would
be darn close to my goal. (10"x7") And I would
probably be offered a film contract too!!!
Thanx Phat8!

BigBoy, Phat8: what kind of pumps do you use? I'm looking for a good all-in-one solution that I don't have to assemble from different parts/manufacturers. I'm not getting girth gains from jelquing and that's what I really need. thanks from Dangleboy

D.B check out the one at rite aid, its not real large but the pump sure works good..PS write me in response to the last e-mail I sent you, I have people waiting for a decision OK? Thanks mvr.

mvr1256, are you sreious? You can buy pumps at rite aid? Penis pumps? Think I'd be a bit embarrassed to but that there.

Carl the pump at rite-aid is really good, 1-3 pulls of the plunger and you’re up to quite a bit of vacuum. I altered the pump a bit; you see the tube screws onto the pump and is sealed by an O-ring. I drilled a hole into the inner portion of the pump and placed a small piece of copper tubing, that way I could use the same pump by attaching some tubing on my big "homemade tube" or use it with the rite-aid tube. The rite-aid tube is a squeeze though, its only 2and3/8" ID. It comes close to 9" long though; I pump up till I feel a good pull. Then I do stretches with the tube, pulling hard and moving my hand in big circular motions, while getting the pump at the same time. Then I finish off with jelging for 30-45 min...OH concerning buying it at Rite-Aid, just go to the counter look past the clerk while looking at their forehead, and buy it, its a quality product, and you'll never see those people again anyway. Oh also how do you men feel about GLASS tubes are they safe? I think I know where I might be able to obtain some round glass tubes about 4”across by 10” long, or some rectangular ones aprox; 4”x4” by 10-12” I’ve noticed the “Tea” pump tube and its glass? Please give you’re thoughts..mvr

[Big10]

too bad, but the tube is too short...
under 9 is way bad for me...
sounds like a deal though!
PS: My BIG tube is glass, Pyrex to be exact.
pretty nice.

mvr1256, thanks for the info. Where exactly in rite aid is it? Behind the pharmaceutical counter? Is it a standard size? They only have one model? Do you ask for a penis pump? Wow, this seems too weird. Not sure I'll be doing this anyway, but am curious. I'm trying to be completely discreet with my PEing and it would be difficult to pump with the wife around. Sounds like a great companion to the jelq and stretch though. Appreciate the info.

[phat9]

Those two are the high end sellers of tubes and pumps. I'd go with one of them, but a quick web search of vacuum pumps will reveal several other sellers of cheaper "parts", such as dual hoses for nipple pumping and connectors, which are all thank goodness, of a "universal" size. So one partfits any brand of pump.

hey all....anyone know a place that i could find a skinny tube...make my own i mean. right now i've been pumping with a homeade lexel caulk tube attached to a good vac gauge, it's opaque though which kind of sucks. but anyway, something clearer and skinnier if possible would be great. any suggestions? thanks in advance.

Carl, its on the retail floor and its not behind the counter, and unless your huge like big bob, it will work. Its not an embarrassing box, (it doesn't say "how to get a big dick" on the box) It’s geared more for the old guy who is impotent, and so the box is discreet.

Thanks mvr1256.

In an attempt to get more girth I got a pump and made my own tube from acrylic with a cap and flare. I thought this was great for a while, but instead of stabilising the length I did gain some girth but I got angry because I lost 1/2" of hard earned length. This was not a skinny tube but 1/4" larger. I can supply the tube part if anyone is interested for $20/30 any length. inc shipping. The pumps are sears or mcmaster. I cant supply them. Only the tube.
Im not in this to make money. Its just a hobby.
The I/D available are 1.34-1.5-1.53-1.73-1.96-2.0-2.12-2.3-2.5-2.7 wall thickness is more than 1/8" Photos available.
hlees@humphreylees.freeserve.co.uk

Hey B.B do you pump and do pe everyday? Also, I may have missed it but, can you give a definition of whats considered a skinny tube, how much larger than a persons present diameter? Thanks mvr.

[Big10]

but I do stretches at every
bathroom break, and whenever
I wake up at night and roll
over. But I just pump and jelq
as a routine M-W-F and take off
T-Th-Sa-Su. I do not want to
over-train, and time is scarce
and will be for about 2 more
months. OT Shutdown at work, big
bucks but little time! That is why
I have the hour plus drive twice a day.

Here is the routine link:
pub14.ezboard.com/fpeforu...1801.topic (http://pub14.ezboard.com/fpeforumsgeneraldiscussion.showMessage?topicID=180 1.topic)