question on measuring

[ghost 07]

Hiya guys.

Lately I've been measuring a lot but I'm still not sure if I'm doing this right, so any help is appreciated:

What I'll do is get a full erection and do a non-pressed bone...thing (i can't remember what it's called.) Anyway I'll measure from the base of my johnson to my head. My wondering is do I measure to the very tip of my head where the opening is or what?

Plz help and thx again.

Note: I use a tape measurer.

[luvdadus]

Whatever you decide on - do the same thing every time.
I favor bone pressed measurements with a ruler for following progress. Perhaps non bone pressed measurements make sense for discussing dick size with females or non pe'ers. Use the same posture, ruler or tape, viewing angle.
Personally I think all pe'ers should do both nbp and bp measurements, refering to each for what they are best suited for. Most vets here when discussing length will be refering to bpel (bone pressed erect length). The method that gives the least varablity is bone pressed flaccid stretch:
flaccid penis stretched out as far as you can, ruler pressed in just short of causing bleeding of the skin you are pressing into. Usually you will get a number from equal to all the way up to 1/2" longer than bpel. Good luck and good gains to you!!