Squeeze bends?

[dewwy]

Ok, so I've been PE'ing for about 5 months now and I've had the hardest of times gaining any girth. I think I've gained slightly more than 1/4" in length, but negligible girth (maybe 1/8").

The first 3 months or so I just jelq'ed and stretched. Pratctically no gains in either department. After that I've started trying more advanced techniques and have seen a little bit of gains. Next measurement is 1 week away!

Ok, so now on to my question

Has anybody seen girth gains from squeeze bending? I'm sure there's a name for it out there. Here's my current routine:

1) flacid stretches/dld blasters for about 15 minutes.
2) Jelq for 50 strokes or so (around 70-80% erect)
3) Squeeze at the base like when doing Uli's
4) Gently bend penis in different directions (I normaly just bend against my left curve). I usually bend for 2-3 seconds and repeat 10 times or so. Whatever feels good.

repeat from 2 until I reaching the desired # of jelq's for the session. I'm doing this routine about 4 days a week.

I'm hoping this could have similar results to erect bending, but maybe less risks. Or is what I'm describing pretty much the same as erect bending? I imagine it's different, since forcing blood into the penis (squeeze) doesn't seem to make it as hard/unbendable as getting a natural erection.

So... thoughts? suggestions? Any girth advice welcome :)

[doublelongdaddy]

Originally posted by dewwy
Ok, so I've been PE'ing for about 5 months now and I've had the hardest of times gaining any girth. I think I've gained slightly more than 1/4" in length, but negligible girth (maybe 1/8").

The first 3 months or so I just jelq'ed and stretched. Pratctically no gains in either department. After that I've started trying more advanced techniques and have seen a little bit of gains. Next measurement is 1 week away!

Ok, so now on to my question

Has anybody seen girth gains from squeeze bending? I'm sure there's a name for it out there. Here's my current routine:

1) flacid stretches/dld blasters for about 15 minutes.
2) Jelq for 50 strokes or so (around 70-80% erect)
3) Squeeze at the base like when doing Uli's
4) Gently bend penis in different directions (I normaly just bend against my left curve). I usually bend for 2-3 seconds and repeat 10 times or so. Whatever feels good.

repeat from 2 until I reaching the desired # of jelq's for the session. I'm doing this routine about 4 days a week.

I'm hoping this could have similar results to erect bending, but maybe less risks. Or is what I'm describing pretty much the same as erect bending? I imagine it's different, since forcing blood into the penis (squeeze) doesn't seem to make it as hard/unbendable as getting a natural erection.

So... thoughts? suggestions? Any girth advice welcome :)

I like this because I think it could be a great pre-cursor to the full bends. Maybe this is even something newbies could work into there program from the start giving them the chance of moving into erect Bends sooner. Usually I would not sugest that a newbie attempt any type of erect work but maybe this will prove to be a good long term warm-up for erect bend...Here is a link to DLD bends: http://www.peforum.net/forum/showthread.php?s=&threadid=5441&highlight=DLD+Bends

[dewwy]

Thanks for the reply dld

I do feel I'm not quite ready for erect bends, and these seem to be a good warmup. I've been doing this for a little over a month now, and will measure this weekend. Hopefully I'll have some gains to report! :)

Also working on a cool progress picture chart that I'm using to keep track of my progress (or lack of it). I'll post it as soon as I have something to show for these months of pe.

[doublelongdaddy]

Originally posted by dewwy
Also working on a cool progress picture chart that I'm using to keep track of my progress (or lack of it). I'll post it as soon as I have something to show for these months of pe.

This is going to be very cool to have.